Fruits and Nuts

Our products are effective with any type of fruit or nut; increasing yield, stand strength, and support against various diseases. Many university studies and independent field tests have been conducted proving the benefit of adding our product to your present fertilizer program. In these research studies, any fruit that was researched had positive results. More research is being conducted on other varieties of fruits with results expected to be the same. Please see the research section if you are interested in what has been done. Below is an outline of general recommended guidelines when using our three products.

SeaCide: Adequate coverage of plant leaves is necessary to provide disease and insect control. SeaCide prevents fungal attack on plant tissue and direct contact activity to insect pressures on the plant. Apply until plant runoff for maximum benefit.

For best mixing performance, do not mix SeaCide with water colder than 40 degrees Fahrenheit. Add sufficient water to the mixing tank before adding SeaCide to allow proper agitation. Add SeaCide when the tank is 1/2 to 3/4 full filling the remainder with water to form a milky appearing solution. For optimum results, keep constant agitation until the solution is used. For application in small equipment without agitation, stir or shake the solution frequently while applying. Care should be exercised in application timing to early moring or late evening to minimize potential for leaf burn and evaporation.

Citrus General Application:

For control of greasy spot, apply SeaCide at a 1-2% solution in combination with copper @ 2 lbs active ingredient per acre as a preventative spray tank mixture.

For control of mites on citrus use SeaCide at a 1-2% spray mixture per acre. For low volume application, apply 0.5 gallons of SeaCide with a minimum of 5 gallons of water per acre.

Small Fruits, Berries and Miscellaneous Crops:

Fungicide Use: Apply SeaCide at a rate of 1% solution per acre. Repeat application every 7-14 days. For low volumes apply 1 quart of SeaCide in a minimum of 5 gallons of water.

Insecticide Use: Apply SeaCide at first sign of pest damage at a 0.5-1% solution in sufficient water to ensure thorough coverage of plant and leaf surface. Repeat application as needed for adequate control every 7-14 days. Larger more mature crops will need higher amounts of water to ensure complete coverage.

Stone, Pome, Tropical Fruits and Nuts

Fungicide Use: Apply SeaCide at a rate of 1-2% solution per acre. Repeat application every 7-14 days. For low volumes apply 1 quart of SeaCide in a minimum of 5 gallons of water per acre.

Insecticide/Miticide Use: Apply SeaCide at a rate of 1-2% solution per acre. Repeat application as needed every 7-14 days. For low volumes apply 1 quart of SeaCide in a minimum of 5 gallons of water per acre.

OmegaGrow and OmegaGrow Plus: Shake well before opening. Separation may occur during storage and shipments. Apply this product only when diluted with water for the desired applications and directions that follow. Do not store or save mixed solutions. Use all that you mix within 24 hours.

Small Fruits, Berries

Application: Soil - apply at 2% solution with transplants at planting. Apply 1 to 3 gallons per acre monthly during growth cycles through drip, flood, furrow, etc. irrigation.

Foliar - apply at 2 to 4 quarts per acre with sufficient amount of water for complete coverage every 7 to 10 days during the growing cycle.

Citrus, Apples, Peaches, Nuts etc.

Young trees: For soil application use 1 to 3 gallons per acre every 2 to 4 weeks during the growth cycle. For foliar application use 1 to 2 gallons every 4 to 6 weeks during the growth cycle.

Mature trees: For soil application use 3 to 5 gallons per acre every 2 to 4 weeks during the growth cycle.For foliar application use 3 to 5 gallons per acre during normal spray cycles (pre-bloom - summer - fall). Apply with sufficient water to ensure complete coverage.